face and the rear of the barrel, so its NOT rubbing and you have about>004-.006 " of an inch, too much gap you can get 'blow by", then the other end, the bottom of the cartridges should NOT 'drag' against the recoil shield. ![]() ![]() Welcome to the forum, on any old model over 150,000 serial number range if you put the cylinder, and pull back ( cock the hammer) and it LOCKS up on every chamber, you should be good to go.look at the spacing in front of the cylinder, between the cyl.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |